Basic Furniture Refinishing

QUESTION: I have a 1930's silky oak drop-door desk that has been in our shed for about 20 years.
It has seen a few cyclones and had a lot of weathering and the doors are off and knobs missing.
This desk holds special memories for me as a young child watching my dad working at it. I’d like to refinish it but have no idea where to begin. How hard would it be for a beginner like me to refinish it?

ANSWER: Your desk sounds like the ideal piece of furniture on which to learn about refinishing furniture. For many beginners, refinishing seems easy, but it’s far from it. First you need to decide if the piece needs to be completely refinished or the original finish preserved. Your desk sounds like it may fall somewhere in between.



It’s only been within the last 20 years or so that refinishing products have appeared that make the job less intimidating. However, most people think you have to strip off all the old finish before applying a new one. That all depends on the condition of the piece.

You piece sounds like it’s been through some tough times. Before you do anything, you need to evaluate it. Has the finish been mostly removed by weathering or is it spotty. If it’s the former, then you’ll need to sand it following the grain of the wood with fine to medium grade sandpaper. If it’s the latter, you may be able to just clean it up and apply a new coat of varnish. With refinishing, a little effort goes a long way. The nearer you can keep your desk to its original condition, the better.

Let’s assume the worst. If the finish has mostly been removed by weathering, you’ll need to remove what remains with a good varnish remover. Be sure to buy one that’s water soluble. Even though this takes longer to achieve the results you want, the fumes are mild and cleanup is easy. When using a remover, always brush it on with the grain of the wood. Do a little section at a time, turning the piece on end if necessary to make it easier to apply the remover. Scrap it off with a putty knife, and be sure to have a roll of paper towels handy to wipe up the excess and stripped varnish or paint.

After you’ve completely stripped your desk of its finish, lightly sand it with fine sandpaper. Wrap the sandpaper around a wooden block for support and sand with the wood grain. Be careful not to over sand----just enough to smooth the surface. After you’re finished sanding, wipe the desk with a damp cloth to remove all the dust. Do not get the wood wet.

Once you have prepared your desk for its new finish, let it rest for a day to make sure the surface is thoroughly dry. Dust it off with a dry cloth to make sure it’s clean, then begin to brush on a new finish using a soft-bristle brush and a furniture finish called tung or Chinese oil. Several manufacturers make this, including Formbys, and you should be able to buy it at your local hardware or home center. Apply the tung oil or a piece of white tube sock or other soft cotton material going with the grain of the wood.. The first coat will soak into the newly stripped wood. Let it dry 24 hours, then sand lightly with fine sandpaper. Dust it with a damp cloth again and let dry. Apply a second coat of the tung oil and repeat the process, except this time rub it with 0000 steel wool after it dries. Dust off again and apply a third and final coat of tung oil, but don’t rub with the steel wool this time.



The advantage to using tung oil is its rapid drying capability. Though it will feel dry to the touch in an hour or so, be sure to let it thoroughly dry for 24 hours. And don’t apply it on a humid or rainy day. And here's a tip: Wrap your application cloth in plastic wrap or put it into a Zip-Loc sandwich bag and place it in your freezer. Take it out 30 minutes before you're ready to apply another coat, and it will be ready for you.

Be sure to tune in next week to learn about preserving the finish of a piece of furniture that isn’t in such bad shape.

To read more articles on antiques, please visit the Antiques Articles section of my Web site.  And to stay up to the minute on antiques and collectibles, please join the over 30,000 readers by following my free online magazine, #TheAntiquesAlmanac. Learn more about  world's fairs in the 2020 Summer Edition, online now. And to read daily posts about unique objects from the past and their histories, like the #Antiques and More Collection on Facebook.

Simple Gifts

QUESTION: I always associated the Shakers with rocking chairs. My grandmother had one, although I’m not sure it was an authentic one. But last Fall I took a trip to Hancock Shaker Village in western Massachusetts and discovered that the Shakers invented a whole host of items, many of which we use in improved forms today. What can you tell me about some of their inventions? And why were they so creative.

ANSWER: The old saying “Necessity is the mother of invention” certainly applied to the Shakers. Since this religious sect lived in communities apart from the outside world, they had to produce everything they needed. And this led to them inventing all sorts of things. And although they made and sold great chairs, especially rockers, to the outside world, they produced so much more.

Today, modern wood workshops wouldn’t be complete without a circular saw. Historians trace the origin of the circular saw blade to 1810 and the Shaker community at Harvard, Mass. It seemed that a Shaker Sister witnessed two Shaker Brothers cutting wood using a two-person reciprocating saw, and using her experience at spinning, realized she could improve the conventional way of sawing wood. She conceived a circular metal disk with saw teeth on its perimeter. She discussed it with some of the Shaker brothers who made a prototype blade and used water to spin it.  Today, the circular saw blade has been improved to cut everything from wood to concrete.



Mother Ann Lee founded the United Society of Believers in Christ's Second Appearing, which is the sect's true name. She claimed to be the female manifestation of Christ. Persecuted in England, she and some followers came to Albany, N.Y., in late 1774. Ultimately they formed self-sustaining communities in Massachusetts, Connecticut, Maine, Indiana, New Hampshire, New York, Pennsylvania, Ohio and Kentucky.

They became known as Shakers only after arriving in America. It was originally a derisive name given them by outsiders because of the frenzied dancing and shaking that typically took place during their worship services.

The Shakers under Mother Ann Lee believed they should strive for perfection. Using resources efficiently and effectively and finding ways to complete tasks faster and with less effort was a step toward perfection here on Earth.

One of the most common of Shaker inventions was the flat broom. Mother Ann is believed to have said, “There is no dirt in Heaven.” So keeping all the rooms and buildings in Shaker communities clean was a major chore.

And while brooms existed before the Shakers, but they were typically lengths of corn straw tied to a wooden handle. Brother Theodore Bates at the Watervliet, New York, community decided that a broom made with its bristles bound flat and straight would work better than a traditional one, so he devised a way to stitch the straw so as to make it flat when fastened to a broom handle. Shakers everywhere began to make flat brooms, not only for their own use, but to sell to outsiders.

A major obstacle to cleaning floors was heavy furniture. Moving beds in particular posed a problem, so the Shakers invented bed rollers so they could easily move beds to clean beneath them.

Doing laundry for a community of several hundred people was a daunting task. In 1858, Brother David Parker at tire-Canterbury, NH., community designed a steam powered "wash mill." It sped up the laundering process and made the work easier for the sisters assigned to laundry duty.

The Shakers didn't often patent their inventions. but the washing machine was an exception. Not only was it patented, Brother Parker's design won a medal at the 1876 Philadelphia Centennial Exposition. Copies of his wash mill were sold W several big hotels.

Shaker herbs and plant seeds were' sought after because of their consistency and high quality. The Shakers were the first to put seeds in small printed pack-ages for home use. The seeds were sold through stores and by mail order.

The Shakers also invented a spike wheel that produced evenly space holes l; for seeds, and it automatically planted seeds, too. It reduced planting time by about fifty percent.

Poplar trees were abundant in some areas, but the wood wasn't useful for either building or burning. The Shakers, !however, found it was an excellent material for baskets. One of the brothers !devised a machine to split lengths of poplar wood into thin splints that could the he used for basket weaving. And Shaker baskets became another product the World" demanded.



Shaker woodworkers developed a machine for making uniform barrel staves, and another for making broom handles of varying lengths.

The Shakers cared for one another, especially the elderly and those that were sick. They invented several things to make life easier for those who were ill. For example, they invented the tilting or adjustable hospital bed. And most Shaker communities had wheelchairs for the elderly and incapacitated. They were rocking chairs with large wheels akin to today's wheelchairs, and a stabilizing wheel or wheels in the back. The finger splint was a Shaker invention, and they created pill making machines for producing herbs and plant potions.

Only a few brothers took care of household chores. The rest were farmers, so they invented several machines to make their jobs easier, including a hillside plow, a horse drawn mowing machine and a thresher machine. Brother Hewitt Chandler of the Sabbathday Lake, Maine, community created the Maine Mower. which mowed hay fields more efficiently than other available equipment. And Brother Daniel Baird at the North Union, Ohio, community developed the revolving harrow used to breakup soil for planting.

And while brothers were busy in the fields, sisters tended to the feeding the community. Feeding several hundred people, three times a day, seven days a week was a daunting task, so naturally invention played a major role.

Cooking on an institutional scale presented its own problems. While a housewife might cook one roast or chicken or bake one pie, Shaker sisters had to prepare dozens, sometimes 60 pies a day. To help with them, for example, They invented a double rolling pin, and it's claimed they could roll twice as much pastry dough in half as much time, verses a conventional rolling pin. Peeling apples is no easy task, so a screw-based apple peeler was created to strip the peel from an apple in a matter of seconds. Once peeled, the apples were cut into quarters using an apple splitter, a spike like device invented by Brother Sanford Russell at South Union, Ky.

 Emeline Hart at the Canterbury, New Hampshire, community designed the Revolving Oven. Numerous pies could be baked simultaneously in this oven.

Sisters also invented the slotted spoon, pea shellers, a cheese press, bread kneading machines and even a potato washer. In 1796, the Shakers produced one of America's first cookbooks.

The Shakers even improved on articles of clothing. One of them, the woolen hooded cloak was a staple of every sister’s wardrobe to protect them from the cold blasts of winter. As with the broom, they sold these to the outside world to make money to buy supplies they needed.

Shaker communities attracted some of the best craftspeople and cooks but unfortunately they believed in celebacy. And that didn’t help their future.

To read more articles on antiques, please visit the Antiques Articles section of my Web site.  And to stay up to the minute on antiques and collectibles, please join the over 30,000 readers by following my free online magazine, #TheAntiquesAlmanac. Learn more about  La Belle Epoque in the 2020 Spring Edition, online now. And to read daily posts about unique objects from the past and their histories, like the #Antiques and More Collection on Facebook.